Mirror cell assembly. This view represent the back of the mirror cell.
Mirror cell, primary mirror location.
Mirror cell, primary mirror location, details The white pads are rubber pad used to prevent doors from damaging walls. The black layer on top of them, are felt pad material, cut into small square and glued on the rubber pads, (the back of the felt pad I used, was adhesive).
Mirror cell, side view. primary mirror adjustment. The screws with springs around them, allow the adjustment of the primary mirror, by turning the wing nuts.
Mirror cell, primary mirror in location. The little white ring at the center of the mirror, is simply a student binder stiffener, for hole-punch pages. Its goal is to be at the center of the primary mirror and facilitate the adjustment of it later.
Mirror cell, primary mirror in location. The primary mirror is ready for a real test. It is hold temporarily, by some piece of plastic, later we installed some nylon screws.
Back to top of page.

[home] [users] [back] [next] When you select "home", it bring you to the root of the site, "www.linuxastronomy.org" "users", bring you to a list of some volunteers of the main project of this site. This page is part of the list.

To join us:

Site maintained by Pixo, with the help of other nice people. To send us a message.

Linux is a registered Trademark of Linus Torvald

Back to top of page.